Belmont M-2535 Manual CNC High Speed EDM Drill

Machine Demonstration:
Simulated Lock Wire Hole demonstration. The machine features Soft Spark Technology which gradually increases amperage to improve stability and hole quality. The controller features One Button Cycle Start which will automatically detect the surface with the electrode, set zero, start the high pressure pump, ramp up cutting power, cut to depth, and retract. Standard Auxiliary I/O allows the ability to integrate ancillary devices such as rotary tables, indexers, and work piece handling systems.

One Button Cycle Start
Automatically the electrode will detect the surface, set zero, start the
high pressure pump, ramp up cutting power, cut to depth, and retract

Programmable Wear Compensation Percentage
Retracts the electrode to a safe position after each cycle

Audible Edge Finding and Automatic Center Calculation
Setups are easier and eliminates calculation errors

Soft Spark
Gradually increases amperage to improve stability and hole quality

Auxiliary I/O
Ability to integrate ancillary devices such as rotary tables,
indexers, and work piece handling systems

Linear Glass Scales with 5 Micron Resolution
Provides true, closed loop, position feedback for precise
part positioning accuracy

TRAVEL
X Axis13.7″ (350 mm)
Y Axis9.8″ (250 mm)
Back Slide7.8″ (200 mm)
Guide Height Adjustment5.9″ (150 mm)
Z Axis15.7″ (400 mm)
Open Height
Minimum0.4″ (60mm)
Maximum8.2″ (210mm)
WORK TABLE
Width x Depth23.6″ x 11.8″
(600 x 300 mm)
WORK PAN
Width x Depth27.9″ x 20.4″
(710 x 520 mm)
WEIGHT CAPACITY
On Work Table880 lb. (400 kg.)
GENERATOR
Maximum Average Current30 A, 6 settings
On and Off Time10 settings for each
Capacitors8 settings, 0 to 1.8 μF
FLOOR SPACE AND WEIGHT
Width x Depth x Height43″ x 43″ x 80″ (109 cm x 109 cm x 203 cm)
Machine Tool Weight1,860 lb. (845 kg.)
ENVIRONMENTAL
Room Temperature68 to 77°F (20 to 25°C)
Relative Humidity40%to 55%
UTILITIES
Electrical220VAC ±10%, 3 PHASE, 60 Hz, 3.5 KVA
Air

Note 1: Adjusting the guide height to increase open height will reduce the usable electrode length

* Open Height is measured from the tip of a standard guide.

Illustrations and specifications herein are not binding in detail. Belmont Equipment & Technologies reserves the right to modify and make improvements to these specifications without notice.

SY-M-2535 Wire Lock Nut Holes